So where do I put the leads to the voltmeter on the TPS?
brummy- 01-03-2007
I just recently pulled on the throttle by hand leaving about a 2mm gap between where it sits when closed, and the engine revved up a lot, and would have kept revving if I had not let go.
TORQUERULES- 01-03-2007
So where do I put the leads to the voltmeter on the TPS?
Green is the signal. Ground the other wire from the volt-meter.
TORQUERULES- 01-03-2007
I just recently pulled on the throttle by hand leaving about a 2mm gap between where it sits when closed, and the engine revved up a lot, and would have kept revving if I had not let go.
Sounds like you are pegging the TPS. Hummmm.
brummy- 01-03-2007
I ordered a new TPS, and it should be here tomorrow morning. I'll see if that helps. Everybody so far has mentioned the TPS, so I figured I'd just get an entirely new one without 74,xxx miles on it. Thanks for all the help.
Forumer™ is Voted #1 Free Forum Hosting provider
Build your own community today with the largest message board hosting company.